Battery Charger; Transportation, Storage And Disposal - Husqvarna 520iLX Manuel D'utilisation

LED display
Red error LED flashing
The product does not start
Error LED is lit with red light
Battery
LED display
Green activate LED flashing
Error LED flashing
Error LED is lit

Battery charger

LED display
Error LED flashes
Error LED comes on
Transportation and storage
• The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
16
Possible faults
Overload.
Temperature deviation.
The power trigger and the acti-
vate button are pressed at the
same time.
Dirt in the battery connectors.
The product needs servicing.
Possible faults
Low battery voltage.
The battery is discharged.
Temperature deviation.
Cell difference is too much (1V).
Possible faults
Temperature deviation.
Overvoltage.

Transportation, storage and disposal

Possible action
The cutting attachment is jammed. deacti-
vate the product. Remove the battery. Clean
the cutting attachment from unwanted mate-
rials.
Let the product cool down.
Release the power trigger and the product is
active.
Clean the battery connectors with com-
pressed air or a soft brush.
Contact your servicing agent.
Possible action
Charge the battery.
Charge the battery.
Use the battery in surroundings where tem-
peratures are between -10°C (14°F) and
40°C (104°F).
Contact your servicing agent.
Possible action
Use the battery charger in temperatures between 5°C
(14°F) and 40°C (104°F).
Make sure that the mains voltage is the same as the
shown voltage value on the rating plate on the product.
Remove the battery from the battery charger.
Speak to your service agent.
• Obey the special requirement on package and labels
for commercial transportation, including by third
parties and forwarding agents.
• Speak to a person with special training in dangerous
material before you send the product. Obey all
applicable national regulations.
756 - 007 -