Operation - Husqvarna 520iLX Manuel D'utilisation

To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten too much.
4. Adjust the product to an applicable position.
5. Tighten the bolt.
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do an overhaul of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
• Make sure that all nuts and screws are tight.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
756 - 007 -

Operation

Read and understand the
To assemble the trimmer guard
1. Install the correct trimmer guard for the trimmer
Accessories on page 18 .
head, refer to
2. Hang the trimmer guard on the hook on the plate
holder (A).
3. Bend the trimmer guard around the shaft and attach
it with the bolt (B) on the opposite side of the shaft.
A
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To charge the battery
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
B
11