Symbols On The Product - Husqvarna 535LS Manuel D'utilisation

11. Cylinder cover
12. Starter rope handle
13. Fuel tank
14. Air filter cover
15. Air purge bulb
16. Choke control
17. Handle adjustment
18. Drive disc
19. Operator's manual
20. Hex key
21. Locking pin
22. Combination wrench

Symbols on the product

Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum of 15 m distance to
persons and animals during operation of the
product.
Only use flexible cutting wire. Do not use
metal cutting equipment for grass trimming.
The arrows show the limit for the handle
position.
1445 - 001 - 22.01.2020
Air purge bulb.
Choke.
Fuel.
yyyywwxxxx
Note: Other symbols/decals on the product refer to
certification requirements for some markets.
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirement. Maintenance,
replacement or repair of the emission control devices
and system may be performed by any nonroad engine
repair establishment or individual.
California Proposition 65
WARNING!
The engine exhaust from this
product contains chemicals known
to the State of California to cause
cancer, birth defects or other
reproductive harm.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
3