Symbols On The Product - Husqvarna 426LST Manuel D'utilisation

5. Shaft
6. Loop Handle
7. Stop switch
8. Throttle lockout
9. Throttle trigger
10. Spark plug cap and spark plug
11. Cylinder cover
12. Starter rope handle
13. Fuel tank
14. Air purge bulb
15. Choke control
16. Air filter cover
17. Combination wrench
18. Locking pin
19. Operator's manual

Symbols on the product

WARNING! This product can be dangerous!
Careless or incorrect use can result in
serious or fatal injury to the operator or
others. It is extremely important that you
read and understand the contents of the
operator's manual. Please read the
operator's manual carefully and make sure
you understand the instructions before the
product is used.
Use approved hearing protection and
approved eye protection.
Maximum speed of the output shaft.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
1189 - 001 - 08.07.2019
The product can cause objects to eject,
which can cause injury.
Keep a minimum distance of 15 m to
persons and animals during operation of the
product.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts. Keep a minimum of 15 m
distance to persons and animals during
operation of the product.
The arrows show the limit for the handle
position.
yyyywwxxxx
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
3