Bevel Gear; Troubleshooting; Transportation And Storage - Husqvarna 426LST Manuel D'utilisation

Bevel gear

The bevel gear is filled with the right quantity of grease
at the factory.
Before you use the product, make sure that the bevel
gear is filled 3/4 full with bevel gear grease. Use
Husqvarna special grease.
Usually, it is not necessary to replace the grease in the
bevel gear. Replace if repairs are done.
The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
Spark plug.

Transportation and storage

• Store and transport the product and fuel so that
there is no risk that any leakage or fumes comes in
1189 - 001 - 08.07.2019

Troubleshooting

Possible cause
The stop switch is in the stop position.
The starter pawls cannot move freely.
Incorrect fuel type.
The spark plug is dirty or wet.
The spark plug electrode gap is incorrect.
The spark plug is loose.
Transportation and storage
Procedure
Set the stop switch to the start position.
Remove the starter cover and clean around
the starter pawls.
Let an approved service agent help you.
Drain the fuel tank and fill with correct fuel.
Make sure that the spark plug is dry and
clean.
Clean the spark plug. Make sure that the
electrode gap is correct. Make sure that the
spark plug has a supressor.
Refer to technical data for correct electrode
gap.
Tighten the spark plug.
contact with sparks or open flames, for example,
from electrical machinery, electric motors, electrical
relays/switches or boilers.
17