To Start The Product - Husqvarna 426LST Manuel D'utilisation

2. Push the air purge bulb again and again until the fuel
starts to fill the bulb.
Note: It is not necessary to fully fill the bulb.
3. Move the choke control to the choke position.
WARNING: If the choke is in choke
position when the engine starts, the
cutting attachment starts to rotate
immediately.

To start the product

WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
on page 4 ).
WARNING: The cutting head will start
rotating upon engine start.
1. Use protective gloves.
12
General safety instructions
2. Firmly grasp the throttle trigger lockout (A) and the
throttle trigger (B) with your left hand. Pull the starter
rope handle quickly with your right hand until the
engine fires. Release the throttle trigger after the
engine starts.
CAUTION: Do not use your feet!
WARNING: Do not twist the starter rope
around your hand.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
3. Reset the choke when the engine fires.
4. Let the engine warm up for several minutes before
you operate the product.
5. Make sure the engine runs smoothly.
A
B
1189 - 001 - 08.07.2019