Husqvarna 535LS Manuel D'utilisation page 7

3. Press the throttle trigger lockout and make sure that
it returns to its intial position when you release it.
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
5. Start the product (refer to the instructions under
prepare the product for start on page 12 ) and apply
full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
page 14 .
To do a check of the stop switch
1. Start the engine.
1445 - 001 - 22.01.2020
2. Move the stop switch to the stop position and make
To do a check of the cutting attachment guard
To
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
prevents injuries that occur if you touch the cutting
attachment.
Maintenance on
1. Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
To do a check of the vibration damping system
Note: Use of incorrectly wound cord or an incorrect
cutting attachment increases the level of vibration. See
instructions under
guard and trimmer head on page 10 .
The vibration damping system decreases vibration in the
handles to a minimum which makes the operation
easier. The vibration damping system of the product
sure that the engine stops.
WARNING: Do not use a cutting attachment
without an approved and correctly attached
cutting attachment guard. Refer to,
Accessories on page 19 .
WARNING: Always use the recommended
cutting attachment guard for the cutting
attachment that you use. If an incorrect or
faulty cutting attachment guard is fitted this
can cause serious personal injury. Refer to,
Technical data on page 19 .
damaged.
To assemble the cutting attachment
7