dinotec PREMIUM Guide D'installation, D'utilisation Et D'entretien page 52

Menu
Allows you to access
Menu
the various 'Electrolysis'
Electrolysis
menus.
Boost mode sets the
production value to its
maximum for 24 hours, but
can be stopped at any
point. This function can be
used when chlorine is
urgently needed.
I Boost mode cannot
replace a conventional
'shock treatment' in cases
of water not fit for
bathing. This mode is
intended to prevent rather
than remedy a problem.
Electrolysis
Boost
→ If Boost mode is
activated and the user
relaunches Boost mode,
the mode will restart for
another 24-hour period.
Operation with a flap
position switch:
- Boost mode cannot be
launched with the flap
shut.
- If the flap shuts with
Boost mode activated,
Boost mode automatically
stops.
Allows you to select the
Electrolysis
operating mode of the
Mode XXX
electrolytic cell.
Allows you to carry out a
Electrolysis
calibration of the ORP
ORP Calibration
probe.
Allows you to set the ORP
Electrolysis
ORP Setpoint XXX
value.
Allows you to set the
Electrolysis
production value in ORP
ORP Prod. XXX %
mode.
Function Setting
- %
(Continual production, at
the production setpoint)
- ORP
(Regulation of
production using the
ORP probe, according to
the ORP setpoint and the
ORP production
setpoint)
- OFF
(Deactivation of the
electrolytic cell)
→ The choice of
operating mode can be
seen on the initial
display ("PROD" as %, or
"ORP" in mV).
From 200 mV to 900 mV,
in 10 mV increments.
From 0 to 100 %,
in increments of 10.
Value
by default
― ―
― ―
― ―
670 mV
Navigation
See the "Display/Navigation" diagram on page 20.
To launch Boost mode :
Electrolysis
Boost
N
Boost XX h
XX h : Remaining time in Boost mode.
To stop Boost mode :
Boost XX h
C
Initial display
→ When Boost mode has finished or is manually
stopped, electrolysis continues automatically at the
initial set production value.
See chapter 12.
or press BOOST
21