Recommended Installation - dinotec PREMIUM Guide D'installation, D'utilisation Et D'entretien

I
Whatever the
direction of the cell, respect
the direction of the arrow on
the sleeve (circled below),
according to the direction of
passage of the water.
F A
A : Nut
B : Electrode
C : O-ring (internal Ø 68 mm)
D : Stopper
E : O-ring (internal Ø 18 mm)
F : Piping
1) If piping F has an outside diameter of 50 mm, cut the piping to a length of 249 mm.
If piping F has an outside diameter of 63 mm, cut the piping to a length of 235 mm.
2) Sandpaper on all surfaces to be bonded : F-piping, G-restrictor, H-collar.
3) Slide each nut A on each piping F.
4) Glue each set [ piping
5) Wait until the collages are completely dry.
6) Place each T-joint I inside each collar H.
7) Fasten the muff J to each piping
I
Screw and tighten the nuts
8) Fit the sets [ A - B - C

RECOMMENDED INSTALLATION

Exploded view of the assembly :
mounting
D
E
G H I
G
H
I
J
K
F - restrictor G - collar
F with the nuts A.
A by hand.
], [ C - K - A ] and [ D - E
A
B
C
J
E
D C
K
A
: Restrictor
(to be installed only if the
: Collar
: T-joint
: Muff
: Flabby
H ].
] on the muff J.
I H G
F pipe has an outside diameter of 50 mm)
A F
13