dinotec PREMIUM Guide D'installation, D'utilisation Et D'entretien page 47

Orp - Cl
: ORP probe connection.
S/T° - flow
: - Connection for salt/temperature/low-water sensor.
- It is also possible to connect a flow sensor.
→ To connect a flow sensor, use the adaptor supplied with it.
Cov - Ext
: Connection for a flap position switch.
→ Use the connector below provided :
Directly insert the cables of the position switch into terminals ❹.
(To remove the cables, apply pressure to the strips
pH
: pH probe connection.
Cell
: Connection for the cell using the corresponding power cable.
❹ ❹
❺
❺
❺
using a flathead screwdriver.)
16