Installing The Accessories Holder; Installing The Salt/Temperature/Low-Water Sensor; Installing The Pool Ground (Optional) - dinotec PREMIUM Guide D'installation, D'utilisation Et D'entretien

6.3. Installing the accessories holder

1) Remove the 5 stoppers and 2 reducers from the
accessories holder.
2) Following the image and instructions shown opposite,
install the accessories holder with or without the 2
reducers (depending on the diameter of the pipe).
3) Depending on the elements to be connected to the
accessories holder, screw back up and tighten by hand
the plug(s) required in the accessory holder, using
sealing tape (not supplied).

6.4. Installing the salt/temperature/low-water sensor

4
15

6.5. Installing the Pool Ground (optional)

15
14
3
11
• You must comply with the specifications of installation standards in the country and at the time of the
installation.
• The ground rod should be sited at a distance and unaffected by any other electrical ground device/rod.
• The ground rod must be at least 1.5 m long.
• The ground into which the ground rod is inserted should be as wet as possible, and have a resistance of
less than 20 Ω.
Screw and tighten by hand the salt/temperature/water
shortage sensor 4 in the accessories holder 15, without using
sealing tape.
The Pool Ground is intended for functional and not safety
purposes. It enables static electricity, whatever its source may
be, to be transferred from the pool water to the ground. In
some cases, static electricity can stimulate the oxidation of
metal parts in contact with pool water. Static electricity can
also disturb the working of probes, which can lead to the
equipment as a whole not working correctly.
1) Without applying Teflon tape, screw in and tighten the Pool Ground by hand
the accessories holder 15.
2) Connect the pool earthing device
cable without isolating sleeve
3) Insert the whole ground rod
Marking "FLOW" with arrow
(showing the flow direction of the water):
on the top left of the accessories holder.
14 to a ground rod
3 (not supplied).
11 into the ground.
I
Water flow direction
11 (not supplied) using a copper
14 into
8