Electrical Connections - dinotec PREMIUM Guide D'installation, D'utilisation Et D'entretien

6.10. Electrical connections

AC
AC
: Power cable connection for electronics unit (220 V - 50/60 Hz).
• Before connecting the power cable to the electronics unit, make sure that the electrical installation
complies with the standards and regulations in force in the country of installation.
• The connection must be carried out by a qualified electrician.
• Do not use an extension cord.
• Do not connect the electronics unit to an electrical outlet.
• Disconnect the power supply at the circuit breaker beforehand and make sure that the power
supply is switched off using suitable tools.
I
Permanently connect the electronics unit to the electrical unit, by linking it to the filtration pump
contactor. (Reminder : a sufficient flow of water must be maintained in the electrolytic cell when connected
to a power supply)
Note : The drawer ❶
a spare fuse ❸ (not provided) :
Electronics unit connectors :
❶
Orp
Cl
contains a fuse ❷ (6.3A time-delay fuse - 5x20mm), as well as a compartment to store
S/T° Cov
flow Ext
H
pH
Cell
❷
❸
❶
15