Operation; Overload Protection - Delta 36-790 Manuel D'utilisation

HOW TO ATTACH THE MITER gAUgE ANd STOP-ROd ASSEMBLY
1. Insert the miter gauge bar (A) Fig. 27 in the T-Slot of the saw table. The t-slot miter gauge bar will prevent the miter
gauge from falling when it is extended beyond the table surface.
2. Loosen the lock knob (A) Fig. 28 and insert the end of the stop rod (D) in the hole on the side of the miter gauge
body.
3. Tighten the lock knob (A) Fig. 28.
OPERATIONAL CONTROLS ANd AdJUSTMENTS
HOW TO START ANd STOP THE MACHINE
The start/stop switch is located at the front of the machine.
To start the machine, push the green button (A). To stop the
machine, push the large red button (B).

OVERLOAd PROTECTION

This machine will shut the motor down because of overloading
or low voltage.
If the machine shuts down, let it cool for about five minutes,
then push the green start button.
IMPORTANT: If the saw shuts off frequently, have a qualified
electrician find the problem and correct it.
HOW TO CHANgE THE BLAdE
Shut off the power source to the machine.
1. Remove the blade guard and the table insert.
NOTE: Remove the splitter assembly ONLY if the thickness of the replacement blade is different from the original blade.
2. Raise the blade to its fullest height.
3. Push the arbor lock button down and use the provided arbor wrench to remove the arbor bolt. Turn the wrench
toward the front of the saw.
4. Position the new blade on the saw arbor. Replace the blade flange, the space, the retainer, and the arbor bolt.
5. Push the arbor lock button down, and tighten the blade assembly by turning the wrench toward the rear of the
saw.
6. Replace the table insert and the blade guard. If you removed the splitter assembly, replace it.
NOTE: If the new blade is of a different thickness from the old blade, refer to "HOW TO ATTACH THE BLAdE gUARd
ANd SPLITTER ASSEMBLY" for proper placement of the splitter.
A
Fig. 27

OPERATION

Fig. 30
14
A
d
A
B
Fig. 31
Fig. 28
Fig. 29