Final Preparation; Check Tire Pressure - Ryobi Ryrm8003 Guide D'assemblage

BATTERY
COVER

CHECK TIRE PRESSURE

Check the air pressure in all tires before use. Improper air
pressure will affect handling, steering response, traction,
tire life, level cutting, and operator comfort. Be sure tires are
inflated to the pressure shown below.
NOTE: Tire pressure should only be measured or
adjusted when tires are cold.
Recommended
Pressure
WARNING:
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing seri-
ous personal injury.
ASSEMBLY
FOAM
Fig. 6

FINAL PREPARATION

Front Rear
19 PSI 18 PSI
Fig. 7
CHARGE THE MOWER
See Figure 9.
Mower batteries must be fully charged before first use. To
verify mower batteries are fully charged, check the battery
level indicator.
To charge:
 Insert charger plug into charging port on mower, making
sure it is properly connected.
 Connect charger to power supply using normal household
current of 120 V, AC only, 60 Hz.
 Do not charge in an area of extreme heat or cold.
 Remove the charger from the mower once it is fully charged
and ready for use.
8 — English
Fig. 8