Ryobi P4360 Manuel D'utilisation page 72

NOTICE:
When placing battery pack in your chain saw,
be sure raised rib on battery pack aligns with
groove in chain saw's battery port and latches
snap in place properly. Improper assembly of
battery pack can cause damage to internal
components.
NOTICE:
Remove battery pack from unit. Fill oil tank with
Ryobi Bar and Chain Lubricant before starting
the chain saw. Failure to lubricate the chain will
cause damage to the bar and chain.
CHAIN LUBRICATION SYSTEM
See Figure 6.
 Use Ryobi Bar and Chain Lubricant. It is formu-
lated to perform over a wide temperature range
with no dilution required.
NOTE: Do not use dirty, used or otherwise con-
taminated lubricants. Damage may occur to the
bar or chain.
 Carefully pour the bar and chain lubricant into
the tank.
 Check and fill the oil tank when battery is
recharged, or as needed.
 Depress the oil tank cap once to pump the
lubricant to the chain before starting the saw.
 To keep the chain lubricated while cutting,
depress the oil tank cap once every few minutes.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
STARTING AND STOPPING THE CHAIN
SAW
See Figure 7.
WARNING:
Keep body to the left of the chain line. Never
straddle the saw or chain, or lean over past the
chain line.
OPERATION
SWITCH
TRIGGER
Starting the chain saw:
 Place the chain saw on a flat bare surface and
make sure no objects or obstructions are in
immediate vicinity which could come in contact
with the bar and chain.
 Press and hold the lock-out button. This makes
the switch trigger operational.
 Press and hold the switch trigger, release the
lock-out button and continue to squeeze the
switch trigger for continued operation.
16 - English
LOCK-OUT
BUTTON
SWITCH
TRIGGER
LOCK-OUT
BUTTON
Fig. 6
Fig. 7