Loading The Battery - Hitachi CP-S225W Manuel D'utilisation

B E F O R E U
B E F O R E U
Part Names (continued)
STANDBY/ON Button
KEYSTONE Button
Button
Button
Button
Button
MENU Button
MAGNIFY Button
MAGNIFY Button
MAGNIFY Button
OFF
AUTO Button
Battery Holder
Loading the Batteries
First Loading:
In original packing, the battery is installed in the battery holder of
the remote controller with protection film(the transparent film some
of which is inside the battery folder). Pull out the protection film to
load the battery.
Replacing:
1. See the reverse side of the remote controller.
2. Pinch the groove and pull out battery holder as the drawing right.
3. Remove the worn battery.
4. Install the new battery with "+" side facing.
5. Push in and click the battery holder.
CAUTION
• Incorrect handling of the battery could result in fire or personal injury.The
battery may explode if not handled properly. Be careful in handling the battery
according to instructions of accompaning manual "SAFETY INSTRUCTIONS"and this
manual.
• Use the 3V micro lithium battery type no.CR2025 only.
• When loading the battery, make sure the plus and minus terminals are correctly oriented as
indicated in the remote controller.
• When you dispose the battery, you should obey the law in the relative area or country.
• Keep the battery away from children and pets.
• When not to be used for an extended period, remove the battery from the remote controller.
NOTE
Replace the batteries when remote control transmitter operation becomes difficult.
ENGLISH-4
S E ( c o n t i
S E ( c o n t i
VIDEO RGB
STANDBY/ON
KEYSTONE
MENU
SELECT
MENU RESET
POSITION
MAGNIFY
FREEZE VOLUME
MUTE
OFF
AUTO BLANK
(Refer to Page.8 "OPERATIONS")
Remote Controller
n u e d )
n u e d )
VIDEO Button
RGB Button
MENU SELECT Button
POSITION Button
RESET Button
VOLUME
VOLUME
FREEZE Button
MUTE Button
BLANK Button
Pull out
Battery Holder
Button
Button
"+" side