Connecting The Cable - Hitachi ED-X22 Manuel D'utilisation

RS-232C Communication
RS-232C Communication
1 2 3 4 5
6 8
7 9
CONTROL port
of the projector

Connecting the cable

Turn off the projector and the PC.
1.
Connect the CONTROL port of the projector with a RS-232C port of the PC
2.
in the previous page.
Turn the PC on, and after the PC has started up turn the projector on.
3.
Communications setting
19200bps, 8N1
1. Protocol
Consist of header (7 bytes) + command data (6 bytes).
2. Header
BE + EF + 03 + 06 + 00 + CRC_low + CRC_high
3. Command data
Command data chart
byte_0 byte_1
Action
low high
Action (byte_0 - 1)
Action
1 SET
2 GET
4 INCREMENT
5 DECREMENT
6 EXECUTE
6
RS-232C cable (Cross)
- (1)
RD (2)
TD (3)
- (4)
GND (5)
- (6)
RTS (7)
CTS (8)
- (9)
byte_2 byte_3
Type
low high
Change setting to desired value.
Read projector internal setup value.
Increment setup value by 1.
Decrement setup value by 1.
Run a command.
(1) CD
(2) RD
(3) TD
(4) DTR
(5) GND
(6) DSR
(7) RTS
(8) DTS
(9) RI
byte_4 byte_5
Setting code
low high
Content
1 2 3 4 5
6 8
7 9
RS-232C port
of the PC