Battery Installation And Esc Arming; Battery Selection - Horizon Hobby E-Flite Pawnee Brave Night Flyer Manuel D'utilisation

Battery Installation and ESC Arming

Battery Selection

We recommend the E-fl ite ® 2200mAh 11.1V 3S 30C Li-Po battery
(EFLB22003S30). Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be within
the range of capacity, dimensions and weight of the E-fl ite Li-Po battery packs
to fi t in the fuselage. Be sure the model balances at the recommended CG.
1. Apply the loop side (soft side) of the hook and loop tape (A) to the bottom of
your battery.
2. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
3. Carefully lift the back of the canopy hatch (B) to remove.
4. Install the fully charged battery (C) in the battery compartment as shown.
See the Adjusting the Center of Gravity instructions for more information.
5. Make sure the fl ight battery is secured using the hook and loop strap (D).
6. Connect the battery to the ESC (the ESC is now armed).
7. Keep the aircraft immobile and away from wind or the system will
not initialize.
• The ESC will sound 3 tones (refer to step 6 of the binding instructions for
more information).
• An LED will light on the receiver.
If the ESC sounds only a double beep after the fl ight battery is connected,
recharge or replace the battery.
8. Reinstall the canopy hatch.
A
C C
D
keep hands away from
the propeller. When
armed, the motor will turn
the propeller in response
to any throttle movement.
EN
CAUTION: Always
11