Horizon Hobby E-Flite Pawnee Brave Night Flyer Manuel D'utilisation page 7

Model Assembly Continued
Wing Installation
2. Guide the aileron servo connectors, wing light and navigation light connec-
tors (A) from the wing through the hole in the bottom side of the fuselage.
IMPORTANT: The ailerons must be connected to the receiver's AILE (#2 chan-
nel) with a Y-harness (included) for the AS3X
3. Mount the wing by aligning the 4 wing pins with the respective holes of the
fuselage.
4. Secure the wing into position using the included 2 screws (B).
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
5. Flip the plane over onto its landing gear to gain access through the battery
hatch opening.
6. Connect the aileron servo connectors (C) to the receiver using the pre-
installed Y-harness as shown. The left and right servos can be connected to
either side of a Y-harness.
7. Connect the internal wing light connectors (red JST type connector) to the
light harness (D).
8. Connect the navigation light connectors (servo style connector with only 2
wires) to the light controller (E) located next to the receiver. Make sure to
connect the connector with the black wire facing up.
9. Reinstall the canopy hatch on the fuselage.
Disassemble in reverse order.
Powering on the lights
1. Power ON and OFF the lights by pushing the button (F) left of the receiver.
F
@
system to function properly.
Ail. Servo Connection
C
Navigation
Light Connection
E
A
B
Inte Internal
Wing-Light Wing-Light Connection
D
EN
7