Accessories; Standard Accessories; Optional Accessories - Hitachi DH 30PB Instructions De Sécurité Et Mode D'emploi

English
WARNING:
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Case (Molded plastic) (Code No. 307786) ............................................................. 1
(2) Side Handle (Code No. 303659) ............................................................................. 1
(3) Stopper (Code No. 971786) .................................................................................... 1
(4) Dust Cup (Code No. 971787) .................................................................................. 1
(5) Syringe (Code No. 318085) .................................................................................... 1

OPTIONAL ACCESSORIES ........

1. Drilling anchor holes (Rotation + Striking)
Drill Bit (Taper shank) and taper shank adaptor
(1) Drill Bit (Taper Shank)
20

ACCESSORIES

ALWAYS use Only authorized HITACHI replacement parts and
accessories. NEVER use replacement parts or accessories which
are not intended for use with this tool. Contact HITACHI if you
are not sure whether it is safe to use a particular replacement
part or accessory with your tool.
The use of any other attachment or accessory can be dangerous
and could cause injury or mechanical damage.
(2) Taper Shank Adaptor
(SDS-plus shank)
Cotter (Code No. 944477)
sold separately