Changing The Sound And Display Settings; Menu; Setting The Equalizer (Eq3) - Sony CDX-MP40 Mode D'emploi

Changing the sound and
display settings

— Menu

The following items can be set:
SET (Set Up)
• A.SCRL (Auto Scroll)*
• M.DSPL (Motion Display) — to select the
Motion Display mode from "1," "2," and
"OFF."
– Select "1" to show decoration patterns in the
display and activate Demo display.
– Select "2" to show decoration patterns in the
display and deactivate Demo display.
– Select "OFF" to deactivate the Motion
Display.
2
• BEEP* — to turn the beeps on or off.
Selecting the desired item
Press (SEL) and the desired preset
number button simultaneously.
(SEL) + (3): A.SCRL*
(SEL) + (4): M.DSPL
(SEL) + (6): BEEP*
*1 When no CD is playing, this item will not
appear.
*2 The beep sound is output only when the built-in
amplifier is used.
After the mode setting completed, the display
returns to normal play mode.
Note
The displayed item will differ depending on the source.
To cancel the item, press (SEL) and the preset
number button simultaneously again.
20
1
(page 12).
1
2

Setting the equalizer (EQ3)

You can select an equalizer curve for 7 music
types (XPLOD, VOCAL, CLUB, JAZZ, NEW
AGE, ROCK, CUSTOM, and OFF (equalizer
OFF)).
You can store a different equalizer setting for
each source.
Selecting the equalizer curve
1
Press (SOURCE) to select a source
(radio, CD or MD).
2
Press (EQ3) repeatedly until the
desired equalizer curve appears.
Each time you press (EQ3), the item
changes.
To cancel the equalizing effect, select "OFF."
Adjusting the equalizer curve
You can store and adjust the equalizer settings
for different tone ranges.
1
Press (SOURCE) to select a source
(radio, CD or MD).
2
Press (EQ3) repeatedly to select the
desired equalizer curve.
3
Adjusting the equalizer curve.
1 Press (SEL) repeatedly to select the
desired tone range.
Each time you press (SEL), the tone range
changes.
LOW t MID t HI (t BAL t FAD)
2 Press the volume +/– button
repeatedly to adjust to the desired
volume level.
The volume level is adjustable by 1 dB
steps from –10 dB to +10 dB.
3 Repeat step 1 and 2 to adjust the
equalizer curve.
To restore the factory-set equalizer curve,
press (SEL) for 2 seconds.
After 3 seconds, the display returns to
normal play mode.
Note
When EQ3 is set to "OFF," you cannot adjust the
equalizer settings.