Adjusting The Balance And Fader; Quickly Attenuating The Sound - Sony CDX-MP40 Mode D'emploi

When an MP3 file is played, you can select an
album using the rotary commander.
(With this unit)
To Do this
Skip albums Push in and rotate [once for
– Album selection each album] the control.
To continuously skip
albums, push in and rotate
(and hold) the control.
(With optional unit)
To Do this
Skip discs Push in and rotate [once for
– Disc selection each disc] the control.
To continuously skip discs,
push in and rotate once and
rotate again within 2
seconds (and hold) the
control.
Skip albums 1 To enter Album selection
– Album selection mode, push in, then rotate
and hold the control.
Within 2 seconds,
proceed to step 2.
2 Push in, then rotate
quickly and repeatedly, to
skip albums one by one.
Changing the operative direction
The operative direction of controls is factory-set
as shown below.
To increase
To decrease
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press (SEL) for 2 seconds while
pushing the VOL control.
Adjusting the balance and
fader
You can adjust the balance and fader.
1
Press (SEL) repeatedly until "BAL" or
"FAD" appears.
Each time you press (SEL), the item changes
as follows:
LOW* t MID* t HI* t
BAL (left-right) t FAD (front-rear)
* When EQ3 is activated (page 20).
2
Press the volume +/– button to adjust
the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press (ATT).
After "ATT-ON" momentarily appears, the
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
19