Inserting/Replacing The Batteries; Using The Touchscreen - Bosch UniversalDetect Notice Originale

OBJ_BUCH-3069-001.book Page 22 Tuesday, April 18, 2017 2:39 PM
22 | English
Assembly

Inserting/Replacing the Batteries

Alkali-manganese batteries are recommended for the measuring tool.
Do not use batteries that have a rated voltage of greater than 1.5 V.
To open the cover on the battery compartment 4, push it away from the battery com-
partment in the direction of the arrow. Insert the batteries. When inserting the batter-
ies, ensure that the polarity is correct according to the illustration on the inside of the
battery compartment.
The battery symbol c in the display status bar shows the current state of charge of the
battery.
If the symbol opposite appears in the display status bar, the measuring tool
can continue to be used for up to another 15 minutes. Change the batteries.
Always replace all batteries at the same time. Only use batteries from one brand and
with the identical capacity.
 Remove the batteries from the measuring tool when not using it for extended
periods. When storing for extended periods, the batteries can corrode and self-
discharge.
Operation
 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or variations in
temperature. In case of large variations in temperature, allow the measuring
tool to adjust to the ambient temperature before switching it on. In case of
extreme temperatures or variations in temperature, the accuracy of the measuring
tool and the display indication can be impaired.

Using the Touchscreen

 Do not use the measuring tool if the touchscreen is visibly damaged
(e.g. cracks in the surface etc.).
The display is divided into a status bar f and touchscreen with an information area e
and a navigation area d.
The status bar f shows the current sound setting b, the battery's state of charge c and
the number of pages a (in multi-page menus).
1 609 92A 3P0 | (18.4.17) Bosch Power Tools