Publicité
Les langues disponibles
Les langues disponibles
Fig. D
2
Proper Hand Position (Fig. E)
WARNING:To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
12
and one hand on the battery pack. Hold tool
firmly with both hands to control the twisting action of
the screwdriver.
Fig. E
Variable Speed Trigger and Forward/
Reverse Control Button (Fig. A)
The tool is turned on and off by pulling and releasing
the variable speed trigger
3
. The farther the trigger is
depressed, the higher the speed of the tool. Your tool is
equipped with a brake. The chuck will stop as soon as the
trigger switch is fully released.
A forward/reverse control button
rotational direction of the tool and also serves as a
lock-off button.
•
To select forward rotation, release the trigger and
depress the forward/reverse control button on the right
side of the tool.
1
12
determines the
4
•
To select reverse, depress the forward/reverse control
button on the left side of the tool.
nOTE: The center position of the control button locks the
tool in the off position. When changing the position of the
control button, be sure the trigger is released.
nOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
be avoided.
nOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
Worklights (Fig. F)
CAUTION: Do not stare into worklights. Serious
eye injury could result.
There are three worklights
8
collar
. The worklights will be activated when the trigger
7
switch is squeezed.
The beam will automatically turn off 20 seconds after the
trigger switch is released.
nOTE: The worklights are for lighting the immediate work
surface and are not intended to be used as a flashlight.
Fig. F
8
7
Performing an Application (Fig. A)
WARNING: To reduce the risk of personal
injury, ALWAYS ensure workpiece is anchored or
clamped firmly.
WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
Prior to performing work:
•
Install the appropriate bit or accessory into the chuck.
Refer to Quick-Release Chuck.
WARNING:
•
Do not use this tool to mix or pump easily
combustible or explosive fluids (benzine,
alcohol, etc.).
•
Do not mix or stir flammable liquids
labeled accordingly.
English
located around the chuck
9
Publicité
