Benelli TNT125 2020 Manuel Du Propriétaire page 117

Instrument and control functions
Passenger seat
To remove the passenger seat
1. To remove the rider seat.
EN
3
1
3
2 1
2. Unscrew the 2 screws.
3. Remove the rider seat.
To install the passenger seat
1. Proceed in reverse order.
Adjusting the headlight beam
The headlight beam adjusting knob is
used to raise or lower the height of the
headlight beam. It may be necessary to
adjust the headlight beam to increase
visibility and help prevent blinding onco-
ming drivers when carrying more or less
load than usual.
2
1
Obey local laws and regulations when
adjusting the headlights.
To raise the headlight beams, turn the
knob in direction (A).
To lower the headlight beams, turn the
knob in direction (B).
Adjusting the shock absorber
assembly
Spring pre-load adjustment
The rear shock absorber is itted with an
adjustment ring nut for the pre-load of
spring and a return ring nut.
Adjust the spring pre-load as follows:
To increase the spring preload and there
by harden the suspension, turn the adju-
sting ring in direction clockwise.
To decrease the spring preload and there
by soften the suspension, turn the adju-
sting ring in direction counterclockwise.
At the end of the adjustment, tighten the
ring and ringnut.
B
A
3 - 12
SOFTER
STIFFER
2
1
1. Return ring nut
2. Spring preload adjusting ring