6.13 EXTERNAL BATTERY CHARGER (BA-503, OPTIONAL ACCESSORY NOT INCLUDED)
The external battery charger will charge the standard (BA-500/BA-508) and extended (BA-516) battery.
It is not included as a standard accessory with the system but can be purchased separately. You can
also use your device to charge the battery when it is plugged into an AC or DC power supply.
To use the external battery charger, follow these steps:
1
3
5
7
6.14 TRAVELING WITH THE DEVICE
This device conforms to all applicable FAA acceptance criteria for POC carriage and use onboard
aircraft.
IMPORTANT
It is the responsibility of the patient to check with the specific airline carrier when traveling
domestically and internationally with a POC.
When traveling with the device, be sure to bring the AC Power Supply and the External Battery Charger
(if you have one) with you. It is advisable to use external power (i.e., plugged into a wall) whenever it is
available to keep the battery fully charged.
©2024 Inogen, Inc. All rights reserved.
1. Connect the AC
power plug into an
electrical outlet.
3. Connect the power
output plug into the
external battery
charger.
5. Once the devices are
properly connected,
a solid red light will
illuminate and indicate
that the battery is
charging.
7. Press the battery
latch down and slide
the charger off the
battery.
Page 17 of 120
2
4
6
Check for Errors: If the red light is flashing,
unplug the device and complete steps 1-4
again. If flashing continues, contact your
equipment provider.
2. Connect the AC input
plug into the AC power
supply.
4. Attach the
external battery
charger by sliding it
onto the battery until it
audibly clicks and locks
onto the battery.
6. When the green light
illuminates, the battery
is fully charged.
96-13115-50-01 B