Abus Profiline GSM-Interface Guide D'installation Et D'utilisation page 34

Reset A message is sent when the
Battery battery voltage is normal again
(> 11 V DC).
SIM validity A message is sent 30 days
before expiry of the SIM card.
Test message Transmission of a test message.
The period duration is defined
under "repetitions".
Message Transmission of messages of
provider SIM provider
The text message (SMS) is sent in the following format:
Message structure
Time
Trigger/event
8.5 Follow Me Parameters
8.5.1 General
With the GSM-Interface, you can send voice messages and text messages (SMS
texts) to up to 8 contact telephone numbers. To define the contacts, you specify
their telephone numbers for transmission over an analogue telephone line (PSTN).
You define settings for a possible GSM transmission in the dialling code settings.
8.5.2 Dialling code settings
With the interface function, you can simulate an analogue telephone line over the
GSM network. If the analogue telephone line fails or if no analogue telephone line is
available, the device automatically switches to GSM operation.
This is often useful if the GSM-Interface is connected with an alarm centre that
sends protocols to an emergency service. Possible protocols are the normal
European standards Contact ID and SIA.
The dialling code settings are necessary if transmission is by GSM network instead
of PSTN. Because of codes needed for getting an outside line, dialling codes, etc.,
it is important to make the right settings for transmission to be successful.
IMPORTANT:
You will find the dialling code settings in the GSM software under
"General>>>Extended Menu or under "10.2.2 Parameters" in the SMS commands.
"GSM battery OK"
"SIM expire in 1 month"
"Periodic test"
Example
Security system
01/06/2008 13:35
Intruder Alarm
Basement door
10
-