Abus Profiline GSM-Interface Guide D'installation Et D'utilisation page 40

10.2.1.4 Receiving an SMS acknowledgement
With the SMS commands, you can get an acknowledgement by SMS that the
device has received the SMS command. To obtain this acknowledgement, enter "!"
after the installer code. If the command was successful, you get an SMS with "0", if
unsuccessful, you get an SMS with "1".
"Installer code" "!" "4-digit SMS command" "=" "data 1"
Example:
Setting the user code
Installer code = 0200; command = PWFM; new code = 4444.
0200!PWFM=4444
10.2.2 Parameters
Description of command
RLMD: GSM operating mode
See also 8.1 General.
RSST: GSM signal strength
Minimal GSM signal strength (RSSI
signal).
PSLT: PSTN Loss Delay
Period before switching from PSTN
to the GSM network.
GSLT: GSM Loss Delay
Period before switching from GSM
network to PSTN.
MTDT: Network fault time
Period until an event that switches
an output is sent.
CLDG: Caller ID
Defines whether all or only existing
contacts can send SMS
commands.
ICDS: Block incoming calls
Defines whether incoming calls are
accepted or rejected.
PWFM: User code
For remote access by SMS
PWIN: Installer code
For remote access by PC or SMS
PINC: PIN code of SIM card
PIN code (if used) of SIM card
SYRT: Redials
Number of redials for voice
transmission
Selection
0: GSM Backup
1: GSM Only
2: GSM Main
1: Low Signal
2: Average Signal
3: High Signal
10-255 s
1-255 min
0-255 min
0: Call ID deactivated
6: Call ID activated
0: Incoming voice call
enabled
1: Incoming voice call
disabled
4 digits
4 digits
4-8 digits
0-9
16
Default
0
2
10 s
4 min
30 min
0
0
1234
0200
-
3