Safety Information For Paint Spraying - EINHELL EURO 210/24 Instructions De Service

Anleitung Euro_210-24_SPK1:_
GB
pull the power plug out of the socket by the
cable. Protect the cable from heat, oil and sharp
edges.
9. Look after your compressor
- Keep your compressor clean so that it works
well and reliably. Follow the maintenance instruc-
tions. Check the power plug and cable regu-
larly and have them replaced by a specialist if
you discover any damage. Check any extension
cables regularly and replace if
damaged.
10. Pull out the power plug
- Whenever the compressor is not being used
and before carrying out any maintenance work.
11. Avoid accidental starts
- Make sure that the switch is turned to OFF
before you connect the compressor to the power
supply.
12. Extension cables for outdoor use
- Use extension cables outdoors only if they are
approved and marked accordingly.
13. Concentrate at all times
- Watch your work. Be sensible. Do not use the
compressor if your mind is not on your work.
14. Examine your compressor for signs of dama-
ge
- Before you use the compressor again, carefully
check its safety devices or any slightly damaged
parts to make sure that they are working proper-
ly and as intended. Check moving parts to make
sure that they are in good working order and are
not jammed or damaged. All parts have to be
properly fitted in order to be sure of meeting all
the machineʼs requirements. Damaged safety
devices and parts have to be repaired or
replaced by a customer service workshop unless
otherwise stated in this manual. Damaged swit-
ches have to be replaced by a customer service
workshop. Do not use any tools with a
switch that cannot be turned on and off.
15. Important!
- For your own safety, use only such accesso-
ries and auxiliary equipment as are listed in this
manual or which are recommended and
specified by the manufacturer. There is a high
risk of suffering a serious accident if you use
tools or accessories which are not listed in this
manual or in the catalogue of recommended
tools and accessories.
16. Have an electrician carry out repairs
- Repairs are to be carried out only by a qualified
electrician. If not, the user may suffer serious
accidents.
17. Noise
Use ear muffs when you use the compressor.
12
19.10.2006 15:56 Uhr Seite 12
18. Replacing the power cable
To prevent injury, damaged power cables may
only be replaced by the manufacturer or a quali-
fied electrician.
4.2 Safety instructions for working with
copressed air and blasting guns
Compressors and lines reach high temperatures
during operation. Avoid contact! Risk of burns!
Gases or vapours drawn in by the compressor
have to be kept free of constituents that may
cause fire or explosions inside the compressor.
When you disconnect the hose coupling, hold
the coupling element in your hand to prevent
injury from the whiplashing hose.
Wear goggles when working with the blow-out
gun. Injuries may easily result from foreign
bodies and blasted parts.
Never point the blow-out gun at other persons
and never use it to clean clothes that are still
being worn.

4.3. Safety information for paint spraying

Never process paints or solvents with a flash
point below 55°C.
Never heat paints or solvents.
It is imperative to use filtering equipment (face
masks) when processing harmful liquids. Note
also the information concerning safety precauti-
ons published by the manufacturers of these
liquids.
Smoking is prohibited during the spraying opera-
tion and in the work room. Paint vapours are
highly flammable.
Make sure there are no open fires or open lights
in the work room. Sparking machines are not to
be used.
Do not keep or consume food and drink in the
work room. Paint vapours are harmful.
The details and designations of the Ordinance
on Hazardous Substances, which are displayed
on the outer packaging of the processed materi-
al, must be observed. Additional protective mea-
sures are to be undertaken if necessary, particu-
larly the wearing of suitable clothing and masks.
The work room has to be bigger than 30 m
have sufficient ventilation for spraying and dry-
ing. Never spray into the wind.
It is always imperative to observe the regulations
of your local police authorities when spraying
combustible or hazardous substances.
Never process media such as white petroleum
spirit, butyl alcohol and methylene chloride with
the PVC pressure hose (reduced life span).
3 and