Abicor Binzel ABITIG GRIP Mode D'emploi D'origine page 14

3 Product description
3 Product description
3.1 Technical data
Tab. 1 General torch data (EN 60974-7)
Transport and storage
Relative humidity
Temperature (operation)
Type of use
Type of voltage
DC polarity of the electrodes
Electrode
Switching power of trigger
Tab. 2 Liquid cooling specifications / cable assembly specifications
Liquid cooling specifications
Flow pressure
All details relate to the cable assembly with a standard length of 4 m and
8 m.
Tab. 3
Product-specific welding torch data (EN 60974-7)
Type Type of
cooling
2
150 Air
200 Air
260 W
Liquid
260 W SC Liquid
450 W Liquid
450 W SC
Liquid
500 W Liquid
Interchangeable neck torch AT/WT
2
150 AT
Air
260 W WT Liquid
3
200 AT Air
450 W WT
Liquid
1Pursuant to EN 60974-7, the alternating current (AC) must be specified with 70% of the tested direct current (DC).
2With a 36-mm-long gas nozzle
3With a 52-mm-long gas nozzle
3.2 Figures used
All figures can be found at the start of this document.
EN - 6
−10°C to +55°C
Up to 90% at 20°C
−10°C to +40°C
Manual
DC or AC
Usually negative
Tungsten electrodes suitable for
TIG use, preferably
low-radiation
Max. 1 W (resistive load)
Min. 2.5 bar/max. 3.5 bar
Load Duty cycle
1
DC AC
[A] [A] [%]
150 105 35
200 140 35
260 185 100
340 240 100
400 280 100
450 320 100
500 350 100
150 105 35
260 185 100
180 130 35
400 280 100
ABITIG
Shielding gas (EN ISO 14175)
Voltage rating
Protection type of the device
connections (EN 60529)
Max. arc ignition and stabilisation
voltage
Breakdown voltage 50 Hz
Switching current of trigger
Switching power of potentiometer
Switching voltage of trigger
Cable assembly specifications
Cooling unit power
For further information regarding the available cable assembly designs and
performance data, please refer to the current order documentation.
Electrode Ø Gas flow rate
Max. length 175 mm
[mm] [l/min]
1.0–2.4 5–12
1.6–4.0 7–18
1.0–3.2 7–18
1.0–3.2 7–18
1.6–4.8 7–20
1.6–4.8 7–20
1.6–6.4 7–22
1.0–2.4 5–12
1.0–3.2 7–18
1.6–4.0 7–18
1.6–4.8 7–20
® ®
GRIP, ABITIG GRIP AT/WT
Argon
Peak value of 113 V
IP3X
®
ABITIG GRIP: 12 kV
®
ABITIG GRIP AT/WT: 10 kV
0.01–100 mA
Linear 1 W at 40°C
0.02–42 V (DC and AC)
Min. 800 W
Cooling
Supply Flow
temperature
Max. Min.
[°C] [l/min]
50 0.7
50 0.7
50 0.7
50 0.7
50 0.7
50 0.7
50 0.7