Ego Power+ CS2000 Guide D'utilisation page 26

1. Remove the battery pack from the chain saw.
2. Clean the oil-tank cap and the area around it to ensure that no dirt falls into the
oil tank.
3. Lay the chain saw on a firm, flat surface, so that the oil-tank cap is facing
upwards. Flip the tab of the oil-tank cap and rotate the oil-tank cap
counterclockwise to remove it (Fig. 9).
4. Carefully pour the bar and chain oil into the tank until it fills to the tank. Be careful
not to let the oil spill from the opening. Fill to the bottom of the fill neck. Wipe off
any excess oil.
5. Replace the cap, place the saw upright, and view the level through the oil-
inspection window. Oil should fill the window.
NOTICE:
◾
Use EGO AOL3200 or AOL1000 bar and chain oil for best results. It is specifically
designed to provide low friction and faster cuts.
◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾
Check the oil level frequently and fill when the oil level falls below the minimum
mark. Never operate the chain saw if the oil is not visible.
◾
Do not use dirty, used or otherwise contaminated oil. Damage may occur to the
bar or chain.
◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the tool for a long period of time, be sure the chain is lightly lubricated;
this will prevent rust on the chain and bar sprocket.
◾
To preserve natural resources, please recycle or dispose of oil properly. Consult
your local waste authority for information regarding available recycling and
disposal options.
26
56V LITHIUM-ION CORDLESS 20" CHAIN SAW — CS2000/CS2000-FC