Henry Schein Maxima Turbo Directives D'utilisation page 5

Feed water quality
It is unacceptable to use any liquids, solutions, chemicals, additives to the feed water - the device may be powered only with demineralized or distilled
water of appropriate quality.
No chemicals or additives must be added to the sterilization water, even if they are specifi cally intended for use in steam generators, steam production
or for use as additives in sterilization, disinfection, cleaning or corrosion protection.
The use of incorrect quality water or solutions other than water reduces the effectiveness of sterilization and leads to damage to the device and loss of
warranty.
The total mineral content of the sterilization water must be less than 10 ppm or, in the case of conductivity measurement, it must be less than 15 μS/
cm - therefore tap water cannot be used as feed water for the device.
The table below shows recommended water hardness and conductivity parameters. Permissible parameters of water used for sterilization
• Hardness <0.02 mmol / l
• Conductivity (at 20 ° C) <15 μS / cm
• PH - from 5 to 7.5
Maxima Turbo - 5