Publicité
Les langues disponibles
Les langues disponibles
SG smart grid
EVU Photovoltaic signal
1
0
0
1
2.4.22 Cool control mode
When it has been activated, it will limit the highest frequency of the compressor for cooling operation.
2.4.23 Heat control mode
When it has been activated, it will limit the highest frequency of the compressor for heating operation.
2.4.24 Highest water pump speed limit function
When it has been activated, there are three options for the highest speed of the water pump, "High", "Medium"
and "Low". "High" is for the speed level 10, "Medium" for level 9 and "low" for level 8. Once it has been set, the
operating speed of the water pump is not allowed to exceed this set value.
2.4.25 Water pump antistall
When it has been activated, it allows to set the antistall interval and antistall duration for the water pump. Once
the main unit has been turned off, the water pump will run at the highest speed for antistall duration every antistall
interval so as to prevent the water pump from being damaged.
2.4.26 Parameter setting
[Operation Instructions]
At the commissioning parameter setting page, by touching "PARAM.", it will go to the pages as shown below.
At this page, select the desired option and then go to the corresponding page.
After that, by pressing "OK", this setting will be saved and then the main unit will run based on this setting; or by
pressing "Cancel", this setting will not be saved and quit.
No.
Full Name
1
T-HP max
T-HP max
[Notes]
●For parameters with different defaults at different conditions, once the current condition changes, the
corresponding default also will change.
●All parameters at this page will be memorized upon power failure.
Command
0
0
1
1
Page of Commissioning Parameters
Display
Range
Name
40~55°C
Switch-off
Switch-off command
command
Standard
Switch-on command
operation
Switch-on
Switch-on signal
signal
Switch-on
Switch-on signal
command
Default
104~131°F
50℃ /122°F
31
Remarks
Remark
/
Publicité
