Publicité
Les langues disponibles
Les langues disponibles
2.4.8 Remote sensor
[Operation Instructions]
At the commissioning parameter setting page, by touching "Remote sensor", the control panel will go to the
corresponding setting page, where it can be set to "With" or "Without".
[Notes]
●This setting will be memorized upon power failure.
●Only when "Remote sensor" is set to "With", the "Ctrl. State" can be set to "T-room".
2.4.9 Air removal
[Operation Instructions]
At the commissioning parameter setting page, by touching "Air removal", the control panel will go to the
corresponding setting page, where it can be set to "On" or "
[Notes]
●This setting will be memorized upon power failure.
not allowed to be turned on.
2.4.10 Floor debug
[Operation Instructions]
1.At the commissioning parameter setting page, by touching "Floor debug", the control panel will go to the
corresponding setting page.
2.At the setting page, "Floor debug", "Segments", "Period 1 temp", "Segment time", and "ΔT of segment"
can be set.
".
pped inside the water system out.
deformed and damaged.
26
On", the main unit is
Publicité
