Publicité
Les langues disponibles
Les langues disponibles
When it is set to "Timer", it is also required to set the "Start timer" and "End timer". Unless otherwise stated,
otherwise time setting is all the same.
This setting will be saved by touching the corner at the upper right corner.
[Notes]
●It can be set under both ON and OFF statuses, but will work only when the main unit is turned on.
●It will be memorized upon power failure.
2.2.6 Weather depend
[Operation Instructions]
At the function setting page, by touching "Weather depend", there will be a choice box, where it is able to set it
to "On" or "Off", and also it is able to set the weather-dependent temperature.
[Notes]
●When "Weather depend" has been activated; it cannot be deactivated by ON/OFF operation but done
manually.
●It is available to find the weather-dependent target temperature at that parameter viewing pages.
●When this function has been activated, it is still allowed to set the room temperature, however, this setting
becomes valid only when "Weather depend" has been deactivated.
●This function can be set to "On" no matter the control panel is turned on or off, but works only when the main
unit is turned on.
●It works under the "Cool" or "Heat" mode. Under the "Cool +Hot water" or "Heat +Hot water" modes, it works
only when the current mode is "Cool" or "Heat". Under the "Hot water" mode, it doesn't work.
●Temperature setting relative to the cooling mode is unallowed to the heating only unit.
●It will be memorized upon power failure.
●When the set point of "Upper WT-Heat"/ "Upper WT-Cool" is lower than that of the "Lower WT-Heat"/ "Lower
WT-Cool", or "Lower WT-Heat"/ "Lower WT-Cool" is higher than "Upper WT-Heat"/ "Upper WT-Cool", a window
will pop up, saying "Enter wrong!", and then resetting is required.
Timer for Quite Mode
Page of the Weather Depend
<-- This is an example; the setting
depends on the installation and its
geographic location.
8
Publicité
