Bosch IXO Notice Originale page 33

OBJ_DOKU-41216-001.fm Page 33 Thursday, October 16, 2014 4:54 PM
Battery Charging (see figure A)
 Do not use other battery chargers. The supplied battery charger is de-
signed for the Lithium-Ion battery in your machine.
 Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Bat-
tery chargers marked with 230 V can also be operated with 220 V.
Note: The battery supplied is partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before using
your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The Lithium-Ion battery is protected against deep discharging. When the bat-
tery is discharged, the machine is automatically switched off by a protective
circuit: The inserted tool no longer moves and a slight whistling noise can be
heard.
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
When the battery charge-control indicator 4 lights up red while the On/Off
switch 7 is depressed half way, then the battery has less than 30% of its ca-
pacity and should be charged.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector 13 is
plugged into the socket 12 on the bottom of the handle.
The charging process is interrupted when the On/Off switch 7 is fully
pressed.
The battery charge-control indicator 4 indicates the charging progress. The
indicator lights up green during the charging process. When the battery
charge-control indicator 4 is no longer lit, the battery is fully charged.
During the charging procedure, the handle of the machine warms up. This is
normal.
Disconnect the battery charger from the mains supply when not using it for
longer periods.
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
Bosch Power Tools
English | 33
1 609 92A 0W7 | (16.10.14)