Publicité
Les langues disponibles
Les langues disponibles
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We wish you lots of fun and success in working with
your new scheppach machine.
Note:
As per the applicable Product Liability Law, the man-
ufacturer of this device will not be liable for damages
that occur in this device or that are caused by this
device in the following cases:
• Improper handling,
• Non-observation of the operating instructions,
• Repair by third parties, unauthorized technicians,
• Installation and replacement with non-original
spare parts,
• Use not in conformity with the manufacturer's
specifications,
• Failures of the electrical system attributable to
non-observation of the electrical specifications
and VDE clauses 0100, DIN 57113 / VDE0113.
We recommend the following:
Please read the instructions in the present manual
carefully before using the tile-cutting machine.
Read the Instructions For Use:
Please read the Instructions for Use carefully before
setting up, commissioning or intervening in the ma-
chine.
Dangerous electric voltage
Caution! Switch off the mains power supply before
making any intervention in the tile-cutting machine.
Risk from sudden start
Caution! The tile-cutting machine can restart sud-
denly after a power failure.
Please read the entire text of the operating instruc-
tions thoroughly before installation and start-up.
This operating instructions manual will help you get
to know the machine and utilize its use options bet-
ter. The operating instructions manual contains im-
portant instructions of working safely, correctly and
economically with the machine, and on how you can
avoid risks, save on repair costs, reduce downtime
and increase the reliability and shelf-life of the ma-
chine.
In addition to the safety clauses of this operating in-
structions manual, you must also observe the specifi-
cations of your country applicable to the operation of
the machine without fail.
24 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Keep the operating instructions manual in a plastic
cover near the machine, protected against dirt and
humidity. It must be read and observed carefully by
all machine operators before starting work on the
machine.
Only persons who are trained to use the machine and
who have been instructed about the risks involved
should be allowed to operate the machine. The re-
quired minimum age of workers must to be observed.
Besides the safety instructions contained in this op-
erating instructions manual and the specifications
of your country, the generally recognized technical
rules of engagement for the operation of the machine
must also be observed.
2. Layout
1
Saw blade protection
2
ON/OFF switch
3
Handle on the cutting arm
4
Machine head
5
Motor
6
Roll slide with rubber coating
7
Stop rail with scale
8
Tub
9
Guide rails
10 Transport handle
11 Feet
12 Base frame
13 Longitudinal aligning stop
14 Diamond cutting wheel (Fig 3.2)
15 Spray guard
16 Water shut-off valve
17 Spring
18 Water pump (Fig. 3.1)
3. Delivery scope
• Stone and tile cutter
• Roll slide with rubber coating
• Diamond cutting wheel
• Lengthwise aligning stop
• Open-ended spanner and Allen key
General instructions
• After removing the packing, check the compo-
nents for possible transport damage. In case of
complaints, please inform the delivery agent im-
mediately. Subsequent complaints will not be en-
tertained.
• Check the delivery to ensure that it is complete.
• Familiarize yourself with the machine with the help
of the operating instructions manual before using
it.
• Use only original parts for accessories as well as
consumables and spare parts. Spare parts can be
obtained from your scheppach retailer.
Publicité
