Husqvarna 320iL Manuel D'utilisation page 15

3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
line to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.
To extend the trimmer line
• When the trimmer line becomes short during
operation, tap the trimmer head on a hard, flat
surface to extend more trimmer line out. You must
operate the product at full speed to get the best
result.
1511 - 013 - 01.11.2023
Clean the trimmer head
Power boost function
You can use the standard mode or the power boost
function.
• Standard mode: The product is set to standard mode
when started. Standard mode saves energy and
gives maximum operation time. Standard mode is
applicable for most tasks.
• Power boost function: The power boost function lets
the product operate at high speed. The power boost
function can for example be used in areas with
thicker grass growth than usual.
To start and stop the power boost function
You can start or stop the power boost function while the
product is in operation.
• Push power boost button. The power boost function
is on when the LED is on.
• Push power boost button. The power boost function
is off when the LED is off.
Note:
If the power trigger is released during operation,
the product starts in the last set function. If the product
automatically stops, or if the operator pushes the power
button, the product is set to the standard function again
when started.
To change the direction of rotation of the
trimmer head
You can change the direction of rotation at full speed or
at stop position. At start, the trimmer head is set to turn
clockwise.
15