Publicité
Les langues disponibles
Les langues disponibles
To attach the cutting attachment guard
•
Attach the cutting attachment guard (A) to the shaft
(C) with the screws (B).
B
C
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery charger to
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
•
Do a general inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
•
Make sure that all nuts and screws are tight.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
1511 - 013 - 01.11.2023
A
Do not use an electric
Operation
Read and understand the
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (A). Use wall plugs (B) if it is necessary.
A
A
2. Install the 2 screw hole plugs (C).
3. Connect the power cord (D) to the battery charger
and a mains socket.
To connect the battery charger
WARNING:
charger in ambient temperatures between
41°F (5°C) and 104°F (40°C).
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded power outlet. The LED on
the battery charger flashes red 1 time and green 1
time.
To charge the battery
CAUTION:
the battery charger and the terminals on the
battery are clean and dry. Do not put the
battery in the battery charger if it is dirty or
wet.
1. Connect the battery charger to a power outlet. The
charging LED flashes red 1 time and green 1 time.
CAUTION:
charger to a power outlet with the
voltage and frequency specified on the
rating plate.
D
Only use the battery
Make sure that the battery,
Only connect the battery
B
C
13
Publicité
