Husqvarna 320iL Manuel D'utilisation page 14

2. Connect the battery to the battery charger. The
charging LED comes on.
3. Remove the battery from the battery charger when it
is fully charged. Push the battery indicator button for
battery status. When all the LED indicators come on,
the battery is fully charged.
4. Pull the power plug to disconnect the battery charger
from the power outlet. Do not pull the power cord.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
Battery information
Refer to the operator's manual of the battery for
information about how to use the battery.
To start the product
1. Push and hold the power button until the green LED
comes on.
14
Only use Husqvarna
If the battery does not
2. Use the power trigger to control the speed.
To operate the product
To trim the grass
• Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line
into the grass.
To clear grass
1. Keep the trimmer head above the ground.
2. Tilt the trimmer head.
3. Cut with the end of the trimmer line around objects in
the work area.
CAUTION:
that are hit by the trimmer line, increases
the wear on the trimmer line.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
Cut grass. Other objects
1511 - 013 - 01.11.2023