Publicité
Les langues disponibles
Les langues disponibles
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
spring works correctly.
4. Start the product. Refer to
page 14 .
5. Apply full power.
6. Release the power trigger lockout and make sure
that the cutting attachment stops fully.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Always use the recommended cutting
attachment guard for the cutting attachment
that you use, see
If an incorrect or faulty cutting attachment
guard is attached this can cause serious
personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the motor.
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.
Battery safety
WARNING:
instructions that follow before you use the
product.
10
To start the product on
Do not use a cutting
Accessories on page 21 .
Read the warning
•
Only use an approved Husqvarna rechargeable
Technical data on page 20 . The
battery. Refer to
battery is software encrypted.
•
Use the Husqvarna battery that is rechargeable as
a power supply for the related Husqvarna products
only. To prevent injury, do not use the battery as a
power supply for other devices.
•
Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
•
Do not use non-rechargeable batteries.
•
Do not put objects into the air slots of the battery.
•
Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
•
Keep the battery away from microwaves and high
pressure.
•
Do not try to disassemble or break the battery.
•
If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
•
Use the battery in temperatures between 14°F
(-10°C) and 104°F (40°C).
•
Do not clean the battery or the battery charger with
To clean the product, the battery and
water. Refer to
the battery charger on page 17 .
•
Do not use a damaged battery.
•
Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
•
Keep the battery away from children.
Battery charger safety
WARNING:
instructions that follow before you use the
product.
•
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
•
Use an approved grounded mains socket that is not
damaged.
•
Only use Husqvarna branded chargers.
•
Do not try to disassemble the battery charger.
•
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
•
Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between objects, for example, doors,
fences or equivalent.
•
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
Read the warning
1511 - 013 - 01.11.2023
Publicité
