DS Produkte VC9391 Mode D'emploi page 23

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

dirty water container (8) fi ts in the frame of the main unit. Press the dirty water con-
tainer (8) against the frame of the main unit until you hear it engage.
Cleaning the Carpet Suction Nozzle
3. Allow the carpet suction nozzle (6) to dry completely and insert it back into the main
unit. To do this, place the locking lugs of the carpet suction nozzle (6) into the recess-
es on the main unit and press down the carpet suction nozzle (6). It must engage
audibly.
Cleaning the Carpet Brush
C
D
3. Rinse out the carpet brush (6) thoroughly under warm, running water.
Cleaning the Upholstery Nozzle
E
F
3. Rinse out the upholstery nozzle and brush insert thoroughly with warm water.
4. Allow all parts to dry completely before assembling them.
07107_DE-EN-FR-NL_A5_V2.indb 23
07107_DE-EN-FR-NL_A5_V2.indb 23
23
1. After cleaning a carpet, clean the carpet suction noz-
zle (6). To do this, fl ip up the closure cap of the hose con-
nection (7). Grip hold of the upper end of the carpet suc-
tion nozzle (6), pull it up and remove (see picture).
2. Rinse out the carpet suction nozzle (6) thoroughly with
warm water.
1. For cleaning the carpet brush (5) place the device on the
fl oor so that the bottom of the device is accessible. Atten-
tion! Make sure you empty the water containers prior
to cleaning.
2. Press together the locking device (C, D) and pull out the
carpet brush (5) (see picture).
4. Allow the carpet brush (5) to dry completely and insert it
back into the main unit. Make sure it is in the correct po-
sition (see picture). Press together the locking device and
press it into the recess on the bottom of the main unit. It
must engage audibly.
1. Clean the upholstery nozzle. To do this, press the button
on the base of the upholstery nozzle (E) and detach the
upholstery nozzle from the hose (see picture).
2. If necessary, remove the brush insert from the upholstery
nozzle. To do this, press down the button on the bottom
of the upholstery nozzle (F) and pull out the brush insert.
EN
26.03.2018 10:36:28
26.03.2018 10:36:28

Publicité

Table des Matières
loading

Table des Matières