DS Produkte VC9391 Mode D'emploi page 21

Cleaning the Carpet
1. Decide where cleaning should start and where it should stop so that you do not
step on the carpet which has already been cleaned. We recommend that right-hand-
ed people should start at the right-hand edge of the carpet, and left-handed people
should start at the left-hand edge of the carpet. Cleaning solution may still escape
from the device even after it has been switched off. Therefore have a towel or cloth
ready on which the device can be placed down after use.
2. Fully unwind the mains cable from the hook for winding up the cable (10, 11), insert
it into the cable holder (16) and connect it to an easily accessible plug socket whose
main voltage matches the technical data of the device.
3. Step on the pedal for tipping the handle (13) and tilt the handle (3) towards you.
4. Step on the On / Off switch (12) to switch on the device.
5. Roll the device to a corner of the carpet.
6. Slide the device forwards along the edge of the carpet and hold down the button for
discharging the cleaning solution (17). This applies the solution to the carpet and
brushes it in. Walk to the side of the device as you do this. Do not tread on the wet
carpet! Once you have reached the other end of the carpet, let go of the button.
7. Pull the device backwards along the same strip. The dirty water will be sucked up.
8. Start the next strip slightly overlapping the strip of carpet that has just been cleaned.
Work up to the other edge of the carpet with even movements forwards and back-
wards. If you fi nd more stubborn patches of dirt, go over a strip several times if nec-
essary.
9. When the dirty water container (8) is fi lled to the Max marking, it must be emptied
(see the "After Use" chapter, "Cleaning the Water Containers" section).
10. When the dirty water container (8) is to be emptied, the fresh water container (2) is to
be topped up or the cleaning is to be fi nished, place the device on the towel or cloth
provided. Switch off the device by stepping on the On / Off switch (12), and move the
handle (1) to a vertical position.
11. Remove the mains plug from the plug socket.
Cleaning Upholstered Furniture
2. Step on the On / Off switch (12) to switch on the device.
A
07107_DE-EN-FR-NL_A5_V2.indb 21 07107_DE-EN-FR-NL_A5_V2.indb 21
21
1. Use the upholstery nozzle for cleaning upholstered furniture. To
do this, fi rst fl ip up the closure cap of the hose connection (7),
place the end of the hose onto the connection and press this
down fi rmly. You must feel it engage.
3. Pull the upholstery nozzle along the edge of the uphol-
stered furniture and hold down the button for dispensing
the cleaning solution on the handle of the upholstery noz-
zle (A) (see picture). Let go of the button (A) at the other
end of the strip.
EN
26.03.2018 10:36:27 26.03.2018 10:36:27