Scheppach HM135B Traduction Des Instructions D'origine page 30

14. Troubleshooting
Fault Possible cause
Motor does not work Motor, cable or plug defective, fuses burnt Arrange for inspection of the machine by a
The motor starts up Voltage too low, coils damaged, capacitor
slowly and does not burnt
reach operating speed.
Motor makes excessive Coils damaged, motor defective
noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps, other motors, etc.)
Motor overheats easily. Overloading of the motor, insufficient cool-
ing of the motor
Saw cut is rough or Saw blade dull, tooth shape not appropri-
wavy ate for the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw
and/or splinters blade not suitable for use
Workpiece pulls away Excessive cutting pressure and/or saw
and/or splinters blade not suitable for use
30 GB
Remedy
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a spe-
cialist. Arrange for replacement of the capacitor
by a specialist
Arrange for inspection of the motor by a spe-
cialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
Insert suitable saw blade