Installation Piccolo Unit Condensing - Tekno Point PICCOLO 12 Manuel D'installation

10. INSTALLATION PICCOLO
UNIT CONDENSING
10.1 PLACE OF INSTALLATION
The installation location should be agreed with the customer,
paying attention to the following points:
- The equipment should be placed in a technical room of
adequate size and in accordance with applicable regulations
in the countries where it will be installed.
- The condensing unit must not be installed outdoors.
- The plan on which will be supported to be able to support
the weight, the rubber feet that is attached to the machine
SHOULD NOT BE REMOVED except in case of use of anti-
vibration spring for installations with wall bracket.
MINIMUM DISTANCES
left/right sade
15 cm
10.2 HYDRAULIC AND REFRIGERATION
The installer is responsible for proper selection and application
of the components according to the national rules and the
recommendations below:
10.3 WATER CONNECTIONS
The hydraulic connections are made on the connections
located on the right side of the machine. Flexible hydraulic
hoses are marked with label indicated the flow: WATER
INLET and WATER OUTLET. Provide a faucet water input
interception, use pipes with an inner diameter corresponding
10.4 REFRIGERANT CONNECTIONS
The refrigerant connections are made on the connections
located on the right side of the machine.
20
30 cm
- The front panel must be inspected, so the front space
should be adequate to permit the operator with all the steps
required during installation, maintenance and assistance
(controls, adjustments, refrigerant charge).
- In case of multiple installations (2 or more PICCOLO) DO
NOT STACK the condensing units.
- The installation must allow authorized personnel to
intervene in case of maintenance, in an easy manner which
respects both the safety distances between the unit and
other equipment that the technical areas mentioned below:
top
30 cm
to the diameter of the connections of the condensing unit
because otherwise it may cause a malfunction (the warranty
is void if they are not used appropriate piping).
The connections for the refrigerant lines are of the "flare".
52
INS CAT
15 cm
50 cm