Wall Mounting - Tekno Point PICCOLO 12 Manuel D'installation

INSTALLATION

8.6 WALL MOUNTING

1. Once covered, place the pipes and run them through the
holes in the wall.
2. Attach the indoor unit to the template.
3. Coat the spaces between the pipes and between pipes and
the holes with the sealing rubber.
4. Fix the pipes in the wall.
5. Check that the indoor unit is installed properly on the wall.
indoor
tube wall
18
outdoor
sealing rubber
- The drain hose must not be over-coated in order to avoid the
obstruction.
- The drain hose must follow the angle of the hole in the wall as
shown in FIG.
- The water outlet can not take place in water so as to discharge
smoothly.
- Tilt the exhaust pipe down slightly. It can not be bent.
The condensate
drain pipe can not be
immersed in water
50
upper hook
lower hook