Cleaning And Maintenance Indoor Unit; Cleaning Filters - Tekno Point PICCOLO 12 Manuel D'installation

4. CLEANING AND MAINTENANCE
INDOOR UNIT
4.1 CLEANING THE PANEL
To clean the I.U. panel, it is recommended to use a soft damp
cloth or dry.
notes:
Do not remove the panel to clean it.

4.2 CLEANING FILTERS

1. Open the panel.
Pull the panel as shown in FIG.
3. Clean the filter.
Use a vacuum cleaner to clean the filter. When the filter is
very dirty, use water (below 45 ° C) to clean it, and then put
it in a shady and cool place
ELECTRICAL DISCONNECT THE UNIT BEFORE ATTEMPTING TO CLEAN IT, TO
PREVENT SHOCK END.
DO NOT CLEAN THE APPLIANCE WITH JETS OF WATER, TO AVOID ELECTRICAL
SHOCK END.
DO NOT CLEAN THE APPLIANCE WITH LIQUID HIGH VOLATILITY.
The filter should be cleaned every three months. If there is a lot of dust in the environment of operation, the frequency
must be increased. After removing the filter, do not touch the fins to avoid injury. Do not use fire or hair dryer to dry the
filter to prevent deformation or fire hazards.
12
2. Remove the filter.
Remove the filter as shown in FIG.
4. Insert the filter.
Insert the filter clean, dry and close the panel.
44
U INS CAT