Descriprion Unit Piccolo; Before Installing - Tekno Point PICCOLO 12 Manuel D'installation

GENERAL INFORMATION
The Owner's Manual is an integral part of the
equipment; it is recommended to read and kept
with care.
Unpack only with equipment placed in the installation
position. After removing the packaging, handling
should be carried out by qualified personnel and
equipped with adequate facilities to the weight of the
structure. The manipulation of the condensing unit
is only permitted in the vertical position maintained
equipment.
2. DESCRIPTION
UNIT PICCOLO

2.1 BEFORE INSTALLING

Before installing the unit, carefully read and store the user
manual and manufacturer's general conditions listed
below.
1. Make sure that the unit corresponds with the needs of the
system.
2. Make sure that the cooling water flow is sufficient for the
proper functioning of the system.
3. Make sure that refrigeration and hydraulic piping is correct
according to the manufacturer's requirements.
4. Assemble the water filter provided to protect the plate
exchanger (water inlet).
5. If impurities are present in the water, perform periodic filter
maintenance.
6. Make sure the electrical connection terminals are powered
by the correct voltage
An incorrect voltage will irreparably jeopardise the main
components of the unit.
7. If alarms are activated, consult the user manual or contact
the manufacturer's service assistance centre.
8. Do not force, for any reason, the operation of the unit, or
tamper or alter the safety devices inside it.
6
(see unit's identification plate).
To disperse the parts of the package, or leave them
within reach of children as they are potential sources
of danger. Packaging must be disposed according to
local legislation.
Check upon receipt that there are no transport
damage and / or handling, and that in the package
are present all desired accessories.
9. Start up cannot be carried out with incomplete, provisional
systems or carried out in a precarious manner.
10. The connections to the unit (hydraulic and electric) must
be carried out by skilled, competent personnel and must
meet all safety standards and health regulations currently in
force in the country in which the unit is used.
11. The technical documentation (diagrams and manuals)
must be kept in good condition in an easily accessible place
for quick reference when needed.
12. The unit should not be used for purposes that do not
correspond with the uses for
which it was built.
13. Respect the technical spaces indicated in this manual to
ensure good access to the unit during maintenance.
14. If damage occurs to the unit caused by the failure to
comply with the above-mentioned points or the information
contained in this manual, the manufacturer reserves the right
to partially or completely void the
guarantee.
15. Contact the manufacturer's Technical Assistance Centre
for further explanation or clarification regarding the
above information.
38
U INS CAT