Publicité
Les langues disponibles
Les langues disponibles
GESTURE CONTROL
The treadmill also has the option of gesture control. The sensors
are located on the left and right of the computer and are denoted
by [-] and [+].
LEFT SENSOR [-]
Moving around the sensor coverage area decrease speed.
RIGHT SENSOR [+]
Moving around the sensor coverage area increase speed.
LEFT SENSOR [-] AND RIGHT SENSOR [+]
Simultaneous actuation of the sensors starts or stops the
treadmill.
FUNCTIONAL TEST
Stand on the sidebars. The normal sensor coverage area is ap-
prox. 5-15 cm above the sensors. Run your hands over the two
sensors. The treadmill should start after a 3 second countdown.
Then move your right hand over the right [+] sensor. The speed
increases as long as the hand is in the coverage area. When you
remove your hand, the speed remains set. Then move your left
hand over the left [-] sensor. The speed decreases as long as the
hand is in the coverage area. When you remove your hand, the
speed remains set. To stop the treadmill, place both hands over
the sensors at the same time. The treadmill is stopped slowly.
Stand on the tread. Follow the same steps to learn gesture
controls while walking/ running.
Attention! Depending on the incidence of light, the coverage
area of the sensor can vary slightly. Familiarize yourself with the
sensors by moving your hand toward, away from, and around the
sensor in the coverage area. You will notice where the sensor
reacts and where not.
-
22
Start/Stop
Start/Stop
Increase
the speed
Decrease
the speed
GB
+
Publicité
