Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE AND ADJUSTING
Lubrication
To ensure that the treadmill runs light and well over long term,
the backside of running surface should always checked for lu-
bricity and, if necessary, treated with silicone oil (no lubricant
based on oil or petroleum). When using less than 3 hours /
week, we recommend lubricating once a year, when using 3-4
hours / week, every six months and when using more than
5 hours / week, lubricate every three months. The lubrication
takes place by the put in silicone oil into the maintenance
opening. To do this, start the treadmill at a slow speed, remove
the rubber plug (4), and dribble some silicone oil (approx. 5ml)
into the opening (5). (Caution! Too much lubricant may cause
the tread to slip.)
Adjusting running belt
You need to adjust the walking belt to the normal position, per
the following steps if it is off. Set speed at 3-5km. Using the
Allen key to adjust the belt tension bolt on the end cap of the
system frame.
1. If you want to move the belt towards left, turn the right ten-
sion bolt clockwise.
2. If you want to move the belt towards right, turn the left ten-
sion bolt clockwise.
If you have already done according to the steps above and it
is still not at the good range, then the running belt should be
damaged already, please contact your local dealer for replace-
ment.
Note: Make sure that the running surface is as centered as
possible. Once these moves too far from the center, (about 10
mm) it should be readjusted into the center.
Running belt slips
a. The running surface is not properly tensioned. Slightly tight-
en both screws on the end caps.
b. Make sure the motor belt is not too loose.
c. Remove excess lubricant with a cloth.
No light on the Display
- Check whether the plug is in the socket and whether the
outlet has power.
- Check that the main switch on the base frame is switched on
and that the safety clip is correctly attached to the pulse grip.
Attention! Always pull out the mains plug when checking the
computer plug connections.
Overload protection
1. Check whether the overload protection (32) has tripped. If
necessary, press the button.
2. The fuse compartment is located between the main switch
and the mains connection socket for the main connection (35).
There is a microfuse 5x20mm with the data 8A/250V.
Abnormal noise from the machine:
- Check if any screw of machine is loose.
- Check if the motor belt is in order.
- Check if the running belt is in order.
Note: You can find further information in the error diagnosis.
Adjustment of the folding lever
In order to set the folding lever appropriately, there is the option
of adjusting the preload with the tool for fold up mechanism
(92) and allen tool (92) supplied. Attention! Do not unscrew
the tension nut (46) completely. Remove the round cap (91)
on the left side of the Treadmill to access the tension nut (46).
Cleaning
Use only a less wet cloth for cleaning. Attention! Never use
benzene, thinner or other aggressive cleaning agents for
surface cleaning as this damage caused. The device is only for
private home use and for use suitable indoors. Keep the unit
clean and moisture from the device.
1.
a.
46
18
4
5
35
93
92
91
GB
2.
32
Publicité
